-
Antenna Isolation
Good morning everyone. I am in the process of designing a simplex based VHF DAS and I’m trying to figure out how to measure isolation between the UL and DL antennas as well as the indoor coverage antennas. Haven’t had much luck figuring it out other than estimated calculations through path loss. Anyone have any experience with this and can provide guidance? The UL antenna will not make physical connections without adding a signal source as well. Much appreciated!
-
1 Reply
-
Hello fella, maybe that can help you, can configure your antenna as a donor by assigning the off air system, remember to set the isolation in the association box. Then in the Prediction panel, check the Donor Antenna Isolation to run the validation. I hope it helps you
Log in to reply.