Find answers, ask questions, and connect with our community around the world.

Home Forums General Forum Antenna Isolation

  • Antenna Isolation

    Posted by Christopher Cisco on January 11, 2024 at 11:43 am

    Good morning everyone. I am in the process of designing a simplex based VHF DAS and I’m trying to figure out how to measure isolation between the UL and DL antennas as well as the indoor coverage antennas. Haven’t had much luck figuring it out other than estimated calculations through path loss. Anyone have any experience with this and can provide guidance? The UL antenna will not make physical connections without adding a signal source as well. Much appreciated!

    Diego_IBW_Lx replied 10 months, 1 week ago 2 Members · 1 Reply
  • 1 Reply
  • Diego_IBW_Lx

    Member
    January 28, 2024 at 7:00 am

    Hello fella, maybe that can help you, can configure your antenna as a donor by assigning the off air system, remember to set the isolation in the association box. Then in the Prediction panel, check the Donor Antenna Isolation to run the validation. I hope it helps you

Log in to reply.